澳洲10计划

澳洲10官方网站

  • Use furnace to sinter raw cathode active material and anode active material.
  • Use milling machine to mill materials into smaller-sized particles.
  • Mix active, conductive and binder material into paste under vacuum using mixer.
  • Use a coater to coat paste onto current collector to create electrode.
  • Use a heater to dry the newly-created electrodes.
  • Use the rolling press (calendar) to roll the electrode to required thickness.

澳洲10现场开奖结果

Winding Method

  • Use Slitting Machine to slice electrode sheet into strips.
  • Weld current collector and tab together using Ultrasonic Welding Machine.
  • Use Winding Machine to wind strips of Anode, Separator and Cathode into cell core.
  • Use Short-Circuit Detector to test the cell’s integrity.
  • Dry the cell using a vacuum oven.

澳洲10全天在线计划

  • Use Deep Spot Welding Machine to weld one tab from the cell to the bottom of the closing end inside cylinder case.
  • After inserting the cell core, use Grooving Machine to groove cell case and fix location of battery core for later sealing.
  • Use Welding Machine to weld the other tab from the cell to the cap.
  • Fill the case with electrolyte in vacuum/globe box using Electrolyte Filling System.
  • Insert & align the cap to open end of case and seal the opening using Sealing Machine inside glove box.
  • Using Battery Analyzer, charge and discharge the assembled battery to activate the cell.
  • Wrap the case with heat-shrinkable PVC for isolation of positive & negative terminals.

澳洲10分析软件

  • Test the newly-created battery’s performance using a Battery Analyzer.
  • Use an Impedance Tester to measure the battery’s internal resistance.

Working alongside organizations including Electrochemical Society and NAATBatt, we’re focused on helping battery manufacturers commercialize ambitious new energy storage technologies.

澳洲10最准的计划

极速赛车群 秒速赛车最快开奖结果 澳洲幸运5预测 秒速飞艇开奖结果下载 极速飞艇网页计划 快乐飞艇龙虎 澳洲幸运10精准计划网站 快乐飞艇计划软件