澳洲10微信群

澳洲10开奖结果计划

  • Use furnace to sinter raw cathode active material and anode active material.
  • Use milling machine to mill materials into smaller-sized particles.
  • Mix active, conductive and binder material into paste under vacuum using mixer.
  • Use a coater to coat paste onto current collector to create electrode.
  • Use a heater to dry the newly-created electrodes.
  • Use the rolling press (calendar) to roll the electrode to required thickness.
Step 2: Li-ion Cell Assembly

Using Stacking Method

  • Use Electrode Mould Cutting Machine to cut electrode out with lead.
  • Use Stacking Machine to stack layers in the following order: Anode > Separator > Cathode > Separator
  • Weld current collector and tab together using Ultrasonic Welding Machine.
  • Use a Short-Circuit Detector to test the cell’s integrity.
  • Dry the cell using a vacuum oven.

Using Winding Method

  • Use Slitting Machine to slice electrode sheet into strips.
  • Use Winding Machine to wind strips in the following order: Anode > Separator > Cathode > Separator
  • Weld current collector and tab together using Ultrasonic Welding Machine.
  • Use a Short-Circuit Detector to test the cell’s integrity.
  • Dry the cell using a vacuum oven.
Step 3: Formation & Sealing of Battery Case
  • Use Cup Forming Machine to punch cup and gas receiver on Aluminum lamination sheet and place cell into cup.
  • After doubling up, seal the appropriate sides using a Top & Side Heat Sealing machine.
  • Use Electrolyte Filling System to fill electrolyte into vacuum/globe box.
  • Seal longer side (where gas receiver is located) using a Vacuum Sealing Machine.
  • Use Battery Analyzer to charge & discharge the cell. This enables battery formation and sends excess gas to gas receiver.
  • Cut off gas receiver and use Vacuum Sealing Machine to finalize sealing on cutting edge under vacuum/glove box.
Step 4: Battery Testing
  • Test the newly-created battery’s performance using a Battery Analyzer.
  • Use an Impedance Tester to measure the battery’s internal resistance.

Working alongside organizations including Electrochemical Society and NAATBatt, we’re focused on helping battery manufacturers commercialize ambitious new energy storage technologies.

澳洲10开奖查询

澳洲幸运10开奖号码 SG飞艇开奖走势 澳洲幸运5一码两期计划 秒速飞艇走势图分析 澳洲10官方网站 澳洲10开奖最快 SG飞艇龙虎和走势图 澳洲8计划群 SG赛车全天两期计划